MODEL : HV - 45A
CURRENT : 45amp
VOLTAGE : 11.0v-46.2v
BEC : OPTO
SIZE : 45*29*8(mm) 1.77*1.14*0.31(in)
WEIGHT (WITH WIRES) : 50g 1.76oz
FEATURES
High rate(10KHz) Switching (PWM) Pulse Width Modulation
Dynamic Braking to ensure prompt prop folding
BEC (2.0amps) provides power to receiver and servos.
Overheat Protected
Low Voltage Cut-off.
Brake Mode
Timing Advance
Motor Rotation
Safe Arming System protects user from startup accidents
Built in Radio Fail Safe
Micro Processor Controlled
USB-LINKER for computer application
NOTE ：
HV-Series signal lead - connect HV-Series unit long signal lead into the throttle channel on your receiver, the short one is for computer connect only. Connect your isolate power to receiver's battery port. Don't operate HV-Series by a servo tester, because it could happened that motor will do some short starts in reason of some incorrect “throttle impulses”. For this we strongly recommend to only using receivers from relevant and reliable manufactories.
HV-Series Low Voltage Cutoff - The customer choice can be only used in computer interface software. Through this way, you can setting the cutoff voltage by yourself. The step is 0.1v up and down.
)